Starting point for automatic installation recovery

If you used the automatic installation process (replacing a release using automatic installation), use the following information to determine where the failure occurred and the appropriate recovery action.

After you have the problem corrected, go to Starting the automatic installation process again.

To use automatic installation recovery, you must use the same version, release, and modification distribution media that caused the failure.
If you have a failure during the automatic installation process and sign on to do problem analysis, your system will be running under the QSYSSBSD controlling subsystem. When your system completes an IPL after the installation has completed successfully, your controlling subsystem is active again.

Where to start recovery for the automatic installation process
Finding the problem (symptom)	Where to start
Reference code B608 1105	Licensed Internal Code recovery
Reference codes other than B900 xxxx	Licensed Internal Code recovery
Reference codes starting with B900 3xxx	Operating system recovery
Messages starting with CPZ20xx	Operating system recovery
Message that indicates the load source disk unit needs additional space for Licensed Internal Code.	Licensed Internal Code recovery
Message that indicates the Licensed Internal Code and operating system software agreements have not been accepted.	Licensed Internal Code recovery
Message that indicates automatic installation is not complete.	Licensed programs, PTFs, and secondary language recovery