Match iSeries system parameters for a 5494 connected by SDLC

You must coordinate communications configuration parameters between the iSeries™ system and the 5494 controller that is connected by SDLC. These parameters are described in the following table. Then the related fields and subfields from the 5494 configuration display are listed next. These values are followed by the iSeries configuration value and the matching 5494 value to be entered in the display subfield. You can coordinate these values automatically or manually. Pick one of these ways:

To automatically connect the iSeries server to a 5494 controller, you can use the automatic remote controller (QAUTORMT) system value.
To manually connect the iSeries server to a 5494 controller, use the following table.

For more information about configuring the 5494, see these books:

IBM® 5494 Remote Control Unit Planning Guide, GA27-3936
IBM 5494 Remote Control Unit User's Guide, GA27-3852

iSeries Prompt	iSeries Parameter	5494 Field	5494 Subfield	iSeries Value	5494 Value	Notes
Connection type	CNN	3	1	NONSWTPP MP	0
			1	*SWTPP	1
			3	*MP	0
			3	NONSWTPP SWTPP	1
Duplex	Duplex	3	2	*HALF	0
Duplex	Duplex	3	2	*FULL	1
NRZI data encoding	NRZI	3	4	*YES	0
NRZI data encoding	NRZI	3	4	*NO	1
Local location name	LCLLOCNAME	H1	1	-	-	Values specified for the iSeries CRTCTLRWS command and for the 5494 Remote Control Unit must match.
Link type	LINKTYPE	AA	-	*SDLC	0,2,3	5494 configuration values must match the values specified for the LINKTYPE parameter on the CRTCTLAPPC command. For APPC controllers that specify LINKTYPE(*SDLC), the value specified in the 5494 configuration must be compatible with the physical interface (INTERFACE parameter) specified on the CRTLINSDLC command. Select 0 for communications using SDLC lines other than X.21 connections.
Remote control point name	RMTCPNAME	13	-	-	-	Values specified for the iSeries CRTCTLAPPC command and for the 5494 Remote Control Unit must match.
Remote network identifier	RMTNETID	11	3	-	-	Values specified for the iSeries CRTCTLAPPC and CRTCTLRWS commands and for the 5494 Remote Control Unit must match.
Remote location name	RMTLOCNAME	12	-	-	-	Values specified for the iSeries CRTCTLRWS command and for the 5494 Remote Control Unit must match.
Station address	STNADR	2	-	-	-	Values specified in the iSeries controller description and for the 5494 Remote Control Unit must match. This value must also be specified as the last 2 digits of the iSeries EXCHID parameter.