Right-click Originator Connection Profiles,
and select New Profile.
Select the following options on the Setup page and click OK:
Protocol type: PPP
Connection type: L2TP (virtual line)
Operating mode: Remote dial
Type of line service: Single line
On the General tab, complete the following
fields:
Name: toModem
Description: originator connection going to partition owning
modem
On the Connection tab, complete the following
fields:
Virtual line name: toModemThis line has no associated
physical interface. The virtual line describes various characteristics of
this PPP profile. The L2TP Line Properties window opens.
On the General tab, enter a description
for the virtual line.
On the Authentication tab, enter the local
host name of the partition and click OK to return to
the Connection page.
In the Remote telephone numbers field, add *PRIMARY and *BACKUP.
This allows the profile to use the same telephone numbers as the terminator
profile on the partition owning the modems.
In the Remote tunnel endpoint host name or IP address field,
enter the remote tunnel endpoint IP address (10.1.1.73).
On the Authentication tab, select Allow
the remote system to verify the identity of this iSeries server.
Under Authentication protocol to use, select Require
encrypted password (CHAP-MD5). By default, Allow extensible
authentication protocol is also selected.
Note: The
protocol should match whatever protocol the server you are dialing also uses.
Enter your user name and password.
Note: The user name
and password needs to match whatever user name and password is valid on the
server to which you are dialing.
Go to the TCP/IP Settings tab and verify
the required fields: