FTP client subcommand
To change the client time-out
limits when the default time-out values are not long enough for a data transfer
to complete successfully, use the DEBUG subcommand. You should only need to
change these values in situations where network traffic or other conditions
cause transfer times to become quite large.
To change the FTP client
time-out values, use the DEBUG FTP client subcommand:
- T1
- Change or display the FTP client time-out limit for reading server replies.
If the FTP client does not receive an expected server reply within this time
limit, the client will close the control connection to the server.
- T2
- Change or display the FTP client time-out limit for transferring data.
If the FTP client does not receive an expected data connection response within
this time limit, the client will close the data connection to the server.
- value
- The time-out limit in seconds. This value must be a positive number greater
than zero. When you omit this value, the client displays the current value
of the time-out limit.
For example:
DEBUG T1 900
This
value sets the client time-out value for server replies to 900 seconds.