The End Controller Recovery (ENDCTLRCY) command ends automatic error recovery procedures for a specific controller. If any type of failure occurs after this command is run, an inquiry message is sent to the system operator.

Use the Resume Controller Recovery (RSMCTLRCY) command to reestablish error recovery procedures for the controller.

Parameters

Keyword	Description	Choices	Notes
CTL	Controller	Name	Required, Positional 1

Top

Controller (CTL)

Specifies the controller whose recovery is to be ended.

This is a required parameter.

Examples

ENDCTLRCY   CTL(TROLL3)

This command ends error recovery procedures for the controller TROLL3.

Error messages

*ESCAPE Messages

CPF2703

Controller description &1 not found.

CPF5924

Controller &1 does not allow automatic error recovery.

CPF5928

Controller &1 not varied on.

CPF5929

Controller &1 assigned to another job.

CPF5935

Error occurred during command processing.

CPF5936

Not authorized to controller &1.