Right-click Responder Connection Profiles and
select New Profile.
On the Setup page, select PPP for
the protocol type.
For Mode selections, select L2TP (virtual line).
Select Terminator (network server) from
the Operating mode drop-down list.
Click OK to PPP profiles properties pages.
On the General page, enter a name that identifies
the type and the destination of the connection. In this case, enter tobranch.
The name you specify must be 10 characters, or less.
Optional: Specify a description for the profile
Go to the Connection page.
Select the IP address of the local tunnel endpoint, 205.13.237.6.
In the Virtual line name field, select tobranch from
the drop-down list. Remember that this line has no associated physical interface.
The virtual line describes various characteristics of this PPP profile; for
example, the maximum frame size, authentication information, the local host
name, and so on. The L2TP Line Properties dialog box
opens.
On the General page, enter a description
for the virtual line.
Go to the Authentication page
In the Local host name field, enter the
host name of the local key server, iSeriesB.
Click OK to save the new virtual line description
and return to the Connection page.
Go to the TCP/IP Settings page.
In the Local IP address section, select
the fixed IP address of the local system, 10.6.11.1.
In the Remote IP address section, select Address
pool as the address assignment method. Enter a starting address,
and then specify the number of addresses that can be assigned to the remote
system.
Select Allow remote system to access other networks
(IP forwarding).
Go to the Authentication page to set the
user name and password for this PPP profile.
In the Local system identification section, select Allow
the remote system to verify the identity of this system. This
opens the Local System Identification dialog box.
Under Authentication protocol to use select Require
encrypted password (CHAP-MD5).