To restart the whole system (perform a power down and an initial
program load (IPL)) the secondary partitions must power down with the primary
partition.
If you are going to restart the primary partition, first power
down all of the secondary partitions.
You can restart a secondary partition
without affecting the other secondary partitions. If the secondary partition
is powered on, you can restart it using PWRDWNSYS OPTION *CNTRLD DELAY (600)
RESTART (*YES). You can use this command from a command line at one of its
workstations or use the Run Command in iSeries Navigator.
| Secondary Partition State |
Unattended IPL |
Attended IPL |
|---|
| Running with i5/OS™ active |
- Use the remote
control panel for the logical partition to select normal mode and to
set the appropriate source (type).
- Right-click the logical partition with which you want to work and select Run
Command.
- Type PWRDWNSYS OPTION (*CNTRLD) DELAY (600) RESTART (*YES) and Click OK.
|
- Use the remote
control panel for the logical partition to select manual mode and to
set the appropriate source (type) .
- Right-click the logical partition with which you want to work and select Run
Command.
- Type PWRDWNSYS OPTION (*CNTRLD) DELAY (600) RESTART (*YES) and Click OK.
|
| Running with i5/OS not
active |
- Use the remote
control panel for the logical partition to select normal mode and to
set the appropriate source (type).
- Use the remote control panel and click the power button. (Delayed power
off).
- Wait for the partition to power off.
- Use the remote control panel and click the power button again.
|
- Use the remote
control panel for the logical partition to select manual mode and to
set the appropriate source (type).
- Use the remote control panel and click the power button. (Delayed power
off).
- Wait for the partition to power off.
- Use the remote control panel and click the power button again.
|
| Not running |
- Use the remote
control panel for the logical partition to select normal mode and to
set the appropriate source (type).
- Use the remote control panel and click the power on button.
|
- Use the remote
control panel for the logical partition to select manual mode and to
set the appropriate source (type).
- Use the remote control panel and click the power on button.
|
See Basic
system operations for more information on performing attended or unattended
IPLs. Operations
Console provides additional information on the remote control panel.