Create the Ethernet line descriptions on the 270 and 8xx model servers

Creating an Ethernet line description is the first step in configuration for the server to use virtual Ethernet. You can use the following steps to configure the 270 and 8xx model servers.

1. On the command line on partition A, type WRKHDWRSC *CMN, and then press Enter.
2. From the Work with Communication Resources panel, select option 7 (Display resource detail) next to the appropriate virtual Ethernet port.

   The Ethernet port identified as 268C is the virtual Ethernet resource. There is one for each virtual Ethernet that is connected to the logical partition.

3. From the Display Resource Detail panel, scroll down to find the port address. The port address corresponds to the virtual Ethernet that you selected during the configuration of the logical partition.
4. From the Work with Communication Resources panel, select option 5 (Work with configuration descriptions) next to the appropriate virtual Ethernet port, and press Enter.
5. From the Work with Configuration Descriptions panel, select option 1 (Create), and then press Enter to see the Create Line Description Ethernet (CRTLINETH) panel.
   1. At the Line description prompt, type VETH0. The name VETH0, although arbitrary, corresponds to the numbered column on the Virtual Ethernet page in which you enabled the logical partitions to communicate. If you use the same names for the line descriptions and their associated virtual Ethernet, you can easily keep track of your virtual Ethernet configurations.
   2. At the Line speed prompt, type 1G.
   3. At the Duplex prompt, type *FULL, and then press Enter.
   4. At the Maximum frame size prompt, type 8996, and then press Enter. By changing the frame size to 8996, the transfer of data across the virtual Ethernet is improved.

      You will see a message stating the line description has been created.

6. Vary on the line description. Type WRKCFGSTS *LIN, and then select option 1 (Vary on) for VETH0.
7. Repeat steps 1 through 6, but perform the steps from the command line on partition B to create an Ethernet line description for partition B.

   Although the names of the line descriptions are arbitrary, it is helpful to use the same names for all of the line descriptions associated with the virtual Ethernet. In this scenario, all the line descriptions are named VETH0.