RouteD work with configuration command

You can use the RouteD Configuration (WRKRTDCFG) command to work with the RouteD configuration.

Use the Work with RouteD Configuration (WRKRTDCFG) command to change the RouteD configuration. The following are two different ways to access this command prompt:

Note: You must have *IOSYSCFG special authority to make changes to the RouteD configuration with the WRKRTDCFG command.
Figure 1. Work with RouteD Configuration command
                         Work with RouteD Configuration
                                                             System:   SYSNAM01
 Type options, press Enter.
   1=Add   2=Change   3=Copy   4=Remove   5=Display   13=Insert
 
       Sequence
 Opt    Number    Entry
 
 _____   00010    # * * * * * * * * * * * * * * * * * * * * * * * * * * *   >
 _____   00020    # RTD DEFAULT CONFIGURATION                               >
 _____   00030    # * * * * * * * * * * * * * * * * * * * * * * * * * * *   >
 _____   00040    #                                                         >
 _____   00050    # RouteD Interface Definitions
 _____   00060    # ----------------------------
 _____   00070    # TCP/IP will learn about a route to network 9.0.0.0 th   >
 _____   00080    # means external to RouteD, therefore do not allow Rout   >
 _____   00090    # route to this network.
 _____   00100    #
 _____   00110    # RIP_INTERFACE * SUPPLY RIP1 METRIC 1 BLOCK 9.0.0.0 MA   >
 _____   00120    #
 _____   00130    #
                                                                        More...
 F3=Exit   F5=Refresh   F6=Print List   F12=Cancel   F17=Top   F18=Bottom
Parent topic: RouteD